Was wondering if the 400kHz is per axis or a total for all.
cheers
Alex
Upto 400kHz step frequency operation UC300ETH
5 posts
• Page 1 of 1
Upto 400kHz step frequency operation UC300ETH
by alex_s » Mon Sep 25, 2017 6:58 pm
- alex_s
- Posts: 65
- Joined: Tue Nov 29, 2016 11:45 am
Re: Upto 400kHz step frequency operation UC300ETH
by ger21 » Mon Sep 25, 2017 6:59 pm
Each axis can output at 400Khz.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: Upto 400kHz step frequency operation UC300ETH
by cncdrive » Mon Sep 25, 2017 8:44 pm
400kHz per axis, I mean every axis can do 400kHz step frequency.
- cncdrive
- Site Admin
- Posts: 4901
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Upto 400kHz step frequency operation UC300ETH
by A_Camera » Tue Sep 26, 2017 8:29 am
alex_s wrote:Was wondering if the 400kHz is per axis or a total for all.
cheers
Alex
Watch out for setting to 400kHz. If your drivers can't handle that (and most of them can't) then it will cause some missing steps and/or stalling.
- A_Camera
- Posts: 639
- Joined: Tue Sep 20, 2016 11:37 am
Re: Upto 400kHz step frequency operation UC300ETH
by alex_s » Wed Sep 27, 2017 11:58 am
A_Camera wrote:alex_s wrote:Was wondering if the 400kHz is per axis or a total for all.
cheers
Alex
Watch out for setting to 400kHz. If your drivers can't handle that (and most of them can't) then it will cause some missing steps and/or stalling.
the Servos and drives ask for a minimum of 125kHz, but if it is 400kHz per axis then all is fine
Thx ger21 and cncdrive for the confirmation.
cheers
Alex
- alex_s
- Posts: 65
- Joined: Tue Nov 29, 2016 11:45 am
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests