I can only upload one picture i post my program picture in the first answer
Thanks in advance
Y z interpolation
2 posts
• Page 1 of 1
Y z interpolation
by Bastian » Mon Nov 25, 2024 8:35 pm
Hello im trying to interpolate y z but it will not make radius the part is milled 45 degrees what am i doing wrong
I can only upload one picture i post my program picture in the first answer
Thanks in advance
I can only upload one picture i post my program picture in the first answer
Thanks in advance
- Bastian
- Posts: 2
- Joined: Sun Nov 24, 2024 4:35 pm
2 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 0 guests