Gerry,
[Thought I'd post this here rather than over on CNCZone, as I/we might get more input from other UCCNC users]
Here goes...
Under the 2017 screen, the Run From Here (RFH) function still uses work coordinates and not machine coordinates. Your Safe Z Height 2 has saved my bacon a couple of times as it's in machine coordinates. Would it be possible to create an option to use the same Safe Z Height 2 for the RFH function?
The couple of times I've tried using RFH after a cycle stop the machine tried to eat itself. It's quite likely (certain, in fact) that I'm making some error when I try to do the RFH, but the UCCNC documentation on what exactly happens during RFH is pretty slim.
If it's not possible, no sweat. If it's possible but a bad idea, maybe you or someone else could explain why in short, easy-to-understand words.
And thank you again for the screen set. Now that I have the TTS system and tool length offsets (mostly) figured out I'm not using the auto-zero function, but everything else is superb.
Regards,
Spumco