forum.cncdrive.com

UCCNC machine control software support forum

Skip to content

Gcode Preview

If you think you've found a bug post it here.
Post a reply

Gcode Preview

Postby MarcoGaspar » Wed Jan 29, 2025 11:56 am

Hello,

Have a program with G54 and G55 but the Gcode preview shows all at the same Workpoint (G54).... It mills at the correct place. (pieces side by side).

UCCNC V2117



Best Regards,
Marco Gaspar
Attachments
2003.zip
(479.71 KiB) Downloaded 81 times
WhatsApp Image 2025-01-29 at 11.46.20.jpeg
2025-01-29 11_48_19-CN.png
MarcoGaspar
 
Posts: 17
Joined: Sun Dec 08, 2024 9:21 pm
Top

Re: Gcode Preview

Postby MarcoGaspar » Sat Feb 01, 2025 8:56 am

This is a bug or an error mine?
MarcoGaspar
 
Posts: 17
Joined: Sun Dec 08, 2024 9:21 pm
Top

Re: Gcode Preview

Postby MarcoGaspar » Thu Mar 06, 2025 10:38 am

No support????
MarcoGaspar
 
Posts: 17
Joined: Sun Dec 08, 2024 9:21 pm
Top

Re: Gcode Preview

Postby cncdrive » Thu Mar 06, 2025 9:48 pm

It depends on the actual offset values.
cncdrive
Site Admin
 
Posts: 5054
Joined: Tue Aug 12, 2014 11:17 pm
Top

Re: Gcode Preview

Postby MarcoGaspar » Fri Mar 07, 2025 10:08 am

Other 2 pieces on machine (side by side)
Attachments
g55.png
G54.png
G54_G55_1.png
MarcoGaspar
 
Posts: 17
Joined: Sun Dec 08, 2024 9:21 pm
Top
Post a reply

Return to Report a bug

Who is online

Users browsing this forum: No registered users and 5 guests

Powered by phpBB® Forum Software © phpBB Group