Esc key press event from macro.
3 posts
• Page 1 of 1
Esc key press event from macro.
by kig23 » Fri May 11, 2018 2:45 pm
I 'm wondering if there is a way to handle esc key press event from macro. Thanks
- kig23
- Posts: 161
- Joined: Sat Mar 31, 2018 6:58 am
- Location: Italy
Re: Esc key press event from macro.
by cncdrive » Fri May 11, 2018 9:39 pm
No, there is no core function for the ESC key.
The ESC key is by default is attached in the hotkeys to call button 130. which is the stop function.
So pressing ESC calls the stop function of the UCCNC by default (setup in the default profile), but ofcourse that hotkey call could be deleted or exchanged from the hotkeys on the hotkeys page.
The ESC key is by default is attached in the hotkeys to call button 130. which is the stop function.
So pressing ESC calls the stop function of the UCCNC by default (setup in the default profile), but ofcourse that hotkey call could be deleted or exchanged from the hotkeys on the hotkeys page.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Esc key press event from macro.
by kig23 » Sat May 12, 2018 6:04 am
Thanks Balazs for this information.
- kig23
- Posts: 161
- Joined: Sat Mar 31, 2018 6:58 am
- Location: Italy
3 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 34 guests