UC100 skipping G code(specifically circles)

[Maxim]

You are correct, I could switch over, but I don't think I currently have the time to learn a new software. Looks like that may be the future though

[andrewbishop66]

Hi all
If I could just add my 2 pence worth or 2 cents for over the pond
I have found that changing from mach 3 to uccnc was not to time consuming and you can use both

But the main point is how much time i saved after the change the whole system just seems to run beter


This is just my point of view others may have had different experiances

Thanks Andrew