Close file button issue.

[kig23]

When you open UCCNC and then press the Closefile button without loading a G-code file in the Toolpathviewer you will see the writing "Loading file" and the loading bar for a while, and in the Codeviewer you'll see a red and white writing "Closed". I'm using UCCNC version 1.2047.

[dezsoe]

In short: yes.

In longer: all versions of UCCNC do the same. I think you have a computer slow enough, if you have time to see this and read all text. Anytime you close a file this happens. UCCNC loads the file Empty.txt in the Contents folder. (Check Diagnostics tab after Close is pressed.) There's no bug, UCCNC works this way.

[kig23]

Thank you.