Hi All
A newbie question. Can I use a pendant controller for mach 3 such as http://www.ebay.com/itm/i-Mach3-M2-USB- ... xy3NBSifKL or one of many others with the UC100 ?
Thanks in advance
Andrew
Using a mach 3 pendant with UC100
3 posts
• Page 1 of 1
Using a mach 3 pendant with UC100
by thegreatwaldo » Tue Oct 18, 2016 11:42 am
- thegreatwaldo
- Posts: 178
- Joined: Tue Sep 06, 2016 8:28 pm
Re: Using a mach 3 pendant with UC100
by ger21 » Tue Oct 18, 2016 2:00 pm
It should work fine. But I haven't tried it.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: Using a mach 3 pendant with UC100
by Magnum » Fri Oct 21, 2016 4:34 am
- Magnum
- Posts: 3
- Joined: Fri Oct 21, 2016 4:31 am
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 14 guests