M5 delay UCCNC+NeuronLite

[tõnisson]

When XY movement stops, there is a 1+ sec delay before torch shuts off.
What could cause a delay that long?



Kristian

[cncdrive]

What is controlling the torch? The UCCNC via a motion controller pin controlled by a M3/M5 or via the Neuron or a combination of both?
If it is controlled by the UCCNC is what I can talk about is that if there is no M5 delay setup then there should be no more than a few tens of milliseconds delay.

If it's controlled by the Neuron then there may be a setting in the plugin which causing the delay, but please ask Andrew (Shad) about this.

[shad]

Hello tonisson!
Please tell me, what plasma cutter do you use?

[tõnisson]

Powermax 85, but Olavi just said, that he sent email directly to you with the problem.



Kristian.

[shad]

Yes Kristian, we try to check it today.