On Page 16 of the User Manual, Enable is labelled Enable port port & pin.
And this line was apparently copied from the Step Port & Pin, and should be removed.
Which is the physical output pin on the UC100 device for the step signal.
Error in User Manual
2 posts
• Page 1 of 1
Error in User Manual
by ger21 » Sun Dec 24, 2017 4:08 pm
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: Error in User Manual
by cncdrive » Thu Dec 28, 2017 4:05 pm
Thanks Gerry, I've corrected the errors now in the documentation.
- cncdrive
- Site Admin
- Posts: 4888
- Joined: Tue Aug 12, 2014 11:17 pm
2 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 19 guests