Coordinate rotate ( G68 G69 )

[Robertspark]

G68 rotate coordinates
G69 cancel coordinate rotation

bit of info here http://www.cnccookbook.com/CCCNCGCodeG68G69CoordinateRotation.htm

(does not appear to be RS274, but Fanuc )

[shad]

Yes, It's will be great!

[X3msnake]

Please implement this


We need this to do auto edge detection and work alignment, I could write a simple macro for my stepcraft probe if this was implemented.


https://www.youtube.com/watch?v=amWolMgEM-Q
https://www.youtube.com/watch?v=5j8GJGqLztU

[X3msnake]

+1

[cncdrive]

This is already implemented.

[X3msnake]

This is already implemented.

Great

How / where can we get the new update

[cncdrive]

From the UCCNC software's webpage on our website: http://cncdrive.com/UCCNC.html
And it is not a new update, it was implemented about half year ago.

[X3msnake]

From the UCCNC software's webpage on our website: http://cncdrive.com/UCCNC.html
And it is not a new update, it was implemented about half year ago.

Greetings

Ok I have checked and in my version 1.2037 G68 does not work neither is listed in the support Gcodes.

You say it was implemented in the middle of the year so I would assume it was in this version?

What am I doing wrong?

[X3msnake]

Ok I installed Version 1.2047 and i see it in the supported Gcodes and it works on MDI

I missed this update because there is no changelog post on the Log forum anouncing this update :\

[cncdrive]

There is a changelog on the forum of every update: http://www.forum.cncdrive.com/viewtopic ... 0&start=40