Strange behavior

[markcadcam]

I have a UC300 and a 5LPT board, Version 1.2037 software. When I went to run my mill this morning it would Home out ok and the Jog was ok. When I would enter info into the MDI window nothing happens, acts like it's locked up until I press the Reset button, no movement. If I load a program, it won't run. Again, acts like it's locked up until I Reset it, no movement. If I press GOTO ZERO nothing happens, again acts like it's locked up. The is no movement, If I run the Default program settings it works fine. I'm not sure where to look for the problem? I changed nothing from when I ran it last.

[markcadcam]

My bad. I had the Feedrate Over Ride set to Zero. Duh.

[Robertspark]

Lol ROFL
Nice!

I needed that