Licence

[smithshane]

Hi
I have a Uc300 usb and a hdbb2 break out board that I have been running for over a year now. I use uccnc software. I have recently had to change computers and install uccnc. I can't get the license to work just demo mode and no blue light on motion controller. Is the license somehow connected to the computer?

[cncdrive]

The license keys are not tied to the computer in any ways.

[dezsoe]

Check UCxxx_utility if it can see the UC300 (don't forget to press Scan ). If not, check cabling, USB ports, their drivers etc.

[smithshane]

Thanks for the replies. Have tried the utility xxx it can't find the device but yet I have a constant green light on the motion controller?

[dezsoe]

The green light means it is powered on. It lights even if operating system not started. The trouble is that the utility cannot find the controller. Check the things I wrote, check also device manager if there is the controller below USB hive. Check the USB port with a USB stick if it works. Check another cable. Until UC300 is not shown in the utility, UCCNC also won't find it.

[cncdrive]

The issue is probably that the USB drivers did not install or were disabled by Windows for some reason.
You can try to follow this document to resolve the issue: http://www.stepcraftsupport.com/wp-cont ... -mode1.pdf

[smithshane]

Back in business thanks for the help.

[dezsoe]

Good news, but what was the problem?