Inches G20 in UCCNC

[cutmastercnc]

I am looking at switching to the UCCNC software. I have been running it in demo mode. Is G20 inches supported or does it only support mm?

[ger21]

UCCNC is unitless. You configure it in the units you use, and use the same units in your g-code.
It doesn't support G20 or G21 to change units.
If you want to run both metric and imperial code, you need to setup a metric profile, and an imperial profile.

[Robertspark]

In case you do not know... create two profiles, copy your shortcuts on your desktop and then edit the shortcuts to add in the following code to the shortcut target section
C:\UCCNC\UCCNC.exe /p NeuronPlasma

change the "NeuronPlasma" to the profile name of your choosing (mm / in??)

..... you can also add in the /d switch for specifying the device preference which can be helpful if you are working in demo mode on a different machine and are developing things on a screenset for another machine for example etc