UCCNC and Super-PID
4 posts
• Page 1 of 1
UCCNC and Super-PID
by jtb223 » Fri Sep 09, 2016 1:45 am
Has anyone set up a Super-PID router controller in UCCNC?
- jtb223
- Posts: 25
- Joined: Fri Sep 09, 2016 1:23 am
Re: UCCNC and Super-PID
by charliem » Fri Jan 06, 2017 12:05 am
Its been a long time sense you asked this . I got my setup working if interested.
Regards
Charlie M
Charlie M
- charliem
- Posts: 108
- Joined: Sun Jan 01, 2017 5:37 pm
Re: UCCNC and Super-PID
by jtb223 » Wed Apr 05, 2017 4:33 pm
Hello Charlie,
I just noticed your response. I would be interested in your experience with your Super-PID and UCCNC. Was it easy to integrate into your system? Is it working well? Any photos available?
thanks,
Jim
I just noticed your response. I would be interested in your experience with your Super-PID and UCCNC. Was it easy to integrate into your system? Is it working well? Any photos available?
thanks,
Jim
- jtb223
- Posts: 25
- Joined: Fri Sep 09, 2016 1:23 am
Re: UCCNC and Super-PID
by Dale » Wed Aug 23, 2017 12:30 pm
I'd be interested in how you got yours setup.
I just got my UC300ETH and am in the process of calibrating the machine, but the spindle keeps running. Can't shut it off.
Dale
I just got my UC300ETH and am in the process of calibrating the machine, but the spindle keeps running. Can't shut it off.
Dale
- Dale
- Posts: 27
- Joined: Mon Aug 21, 2017 12:23 pm
- Location: Alberta, Canada
4 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: Bing [Bot] and 18 guests