A Axis problem from mach to uccnc

[woffler]

I have went back to Mach 3 and loaded the uc400eth plugin and it works fine with the original settings ,so it is the angular A axis that is required for the fourth axis to work correctly.
I have put in a feature request to see if they will add this , please!!!!!!!!!!!

Is it ok to switch between the Mach software and the Uccnc with out creating a huge problem for myself?

[woffler]

I got it going with Robs suggestion in UCCNC at 5400 feed rate ,i will have to remember when programming to multiply the feed rate by 360 .

Thank You for your help