forum.cncdrive.com

UCCNC machine control software support forum

Skip to content

G68.2 and G68.3 Transform Plane

If you have a question about the software please ask it here.
Post a reply

G68.2 and G68.3 Transform Plane

Postby markcadcam » Wed Jun 21, 2017 1:02 pm

Is there any plans on adding G68.2 and G68.3 transform plane?

Thanks
Mark
markcadcam
 
Posts: 97
Joined: Thu Apr 13, 2017 1:52 pm
Top

Re: G68.2 and G68.3 Transform Plane

Postby cncdrive » Wed Jun 21, 2017 1:53 pm

Honestly I do not know what G68.2 and G68.3 and do, so I will need to look it up.
But because I do not know what they are I don't think we have any plans yet to implement them otherwise I would already know what they are. :)
cncdrive
Site Admin
 
Posts: 4887
Joined: Tue Aug 12, 2014 11:17 pm
Top

Re: G68.2 and G68.3 Transform Plane

Postby Robertspark » Wed Jun 21, 2017 2:32 pm

https://www.linkedin.com/pulse/fanuc-g682-5-axis-tilted-work-planes-tim-markoski

complex.... head hurts now...
Last edited by Robertspark on Wed Jun 21, 2017 2:45 pm, edited 1 time in total.
Robertspark
 
Posts: 1892
Joined: Sat Sep 03, 2016 4:27 pm
Top

Re: G68.2 and G68.3 Transform Plane

Postby markcadcam » Wed Jun 21, 2017 2:44 pm

The reason for asking about the G68.2 and 68.3 is based on the programming software we use to program our Hurco VMX30Ui 5 axis machine. We use Worknc software. I built a 5 axis trunion table that mounts on my Bridgeport and runs on UCCNC. I was hoping to use the same post processor to program both machines.
Thanks
Mark
markcadcam
 
Posts: 97
Joined: Thu Apr 13, 2017 1:52 pm
Top
Post a reply

Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 17 guests

Powered by phpBB® Forum Software © phpBB Group