I have a uc400EFT motion control card & I am running mach3 because I am still undecided about uccnc, I have never had a problem with mach3 personally but know that others have switched for one reason or another.
With uccnc when I enter the diagnostic screen the charge pump indicator is constantly flashing, doesn't seem to make any difference if I set it to active low or select charge pump always on. Did try a search on the forum but couldn't find an answer.
Charge Pump indication
3 posts
• Page 1 of 1
Charge Pump indication
by martin54 » Wed May 31, 2017 7:02 pm
- martin54
- Posts: 27
- Joined: Tue May 02, 2017 6:43 pm
Re: Charge Pump indication
by dezsoe » Wed May 31, 2017 9:51 pm
Are you running UCCNC in demo mode? I tried it and in demo mode the indicator for charge pump does not work as it should, but with UC400 connected it works well.
- dezsoe
- Posts: 2093
- Joined: Sun Mar 12, 2017 4:41 pm
- Location: Csörög, Hungary
Re: Charge Pump indication
by martin54 » Fri Jun 02, 2017 10:08 pm
Sorry about the slow reply, been away from the internet. No not running in demo mode, licenced software & UC400EHT motion control board.
It doesn't seem to affect the operation of the machine in any way that I can see but I am still a novice at this sort of thing so it would be very easy to miss something.
It doesn't seem to affect the operation of the machine in any way that I can see but I am still a novice at this sort of thing so it would be very easy to miss something.
- martin54
- Posts: 27
- Joined: Tue May 02, 2017 6:43 pm
3 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 13 guests