Excuses for maybe stupid question but Im new user of all these. I tought I was going right but it do not work
Ok I put the
power suply 35/36 Works ok
Input 1 I used for E stop Contact works on the board but don't work on the software.... (two nc contacts in serial/two e stops) used pin 15 port 1 When pused the led goes out on the board
input 2 used for limit /homing Works on the board but not on the software (5x no npn switch all parallel) used pin 10 port 1 when detected led goes on , on all 5
input 3 used for probe works on the board, cant test because the steppers dont turn. used pin 11 port 1 probe works manualy
First I wanna check off the connections are ok.
All connected with teh UC400eth works ok get connection
Hope someone could drive me in the good direction.
thx Koen (Belgium)
