Huanyang Plugin

[Dan911]

Hi QuebecCNC,

Don't bother downloading the plugin I uploaded for you I determined what your problem is. Go to your spindle set up in UCCNC (CONFIGURATION/AXIS SETUP/SPINDLE) and check "PWM spindle" you have "Step/direction spindle" checked and this is your problem. When I checked this my max rpm went to "11880". You will need to apply/save restart after changing these settings.

I will add this to the set up instructions sometime in future.

Thanks,
Dan

[QuebecCNC]

Great I will test that tonight.

Thanks!

[ger21]

I just uploaded a video I did while testing Dan's plugin.
Excellent work.
https://youtu.be/jmdV3Y_ffyo

[Dan911]

Thank You Gerry, it's such a pleasure getting positive feedback. Normally the only feedback I receive is when someone has a problem. I'm sure you relate to that! lol

Have a Happy Easter Sunday!

Thanks again,
Dan

[Dan911]

Hello All,

I just uploaded a new version of the HYPLUGIN and it really is a difference of night and day compared to original plugin, anyone using this plugin should take a look and download. I also fixed minor bugs and added some new features.

Read and download by following link to bottom of page:


http://www.cnczone.com/forums/uccnc-con ... ost2038336


Dan

[Dan911]

Hello All,

Recently I became aware of a bug that's actually been with the plugin from the beginning. Many haven't experienced it like myself but regardless, it was there and fixed. Anyone using this plugin or decide to give it a try make sure it's "HYPLUGIN10". You can follow link below to post#267 to download.

http://www.cnczone.com/forums/uccnc-con ... in-23.html

Dan

[cncdrive]

Hi Dan,

Thank you for your extensive work with this plugin. I really appritiate it.

[Dan911]

I am extremely happy to share and offer anyone the same option who might of been in same predicament as me. My system was built several years back and a lot of components wasn't available like they are today, at least not reasonably priced. Mach3 was my only option if I wanted to control spindle through software without doing a complete overhaul to my Electrical enclosure, and with everything working perfectly this was a tough move to make. With your UC100, software and plugin I feel like I made this overhaul and my system can compete with most. So...Thank You!!

Dan

[andrewbishop66]

Hi All

Can I use this plugin with other drives my mill spindle inverter has rs485 input will it work or should i stick to my existing spindle control
in the middle of setting up new controller with uc300

have to Gerrys video was impressive

Thanks andrew

[ger21]

It only works with Huanyang VFD's.
Dan has another Modbus plugin at CNC Zone that works with other VFD makes.