AXBB-E 5V Input (stepper driver alarm signal)

[tillibilli]

Hello all,

I've been using an AXBB-E for quite some time and am super happy with it.

However today I realised, that the alarm output of my closed loop stepper driver doesn't put it into reset.
I think this is caused by the signal being 5v, and the AXBB inputs being configured for 10-30V.

Is there any good solution to come around this? Shoul i use a 5-> 24v stepup converter?

Thanks!

[cncdrive]

You could use the 5Volts signal.
Just make sure to configure that input as Reset or Stop.
You can do it in the "Faultsignals" plugin.

[tillibilli]

Oh, thanks a lot for the reply!

Now that i think about it, it's possible that i didn't fully configure this. Will check it out tomorrow, thanks!