Im curently tryng to set up a tool probing , i have the m31 doing its job more or less . Problem is that tool offsets dont populate the tool library ! in the m31 macro there is a line with G44 Hx , but it dosnt seem to store anything . The probing is done in negative direction from G53 Z home , perhaps one of you can see what im missing
- Code: Select all
//
M31 probing macro
double probeX = 120;
double probeY = 588;
double Zmin = -200;
double FeedrateFast = 200;
double FeedrateSlow = 100;
double SafeZ = -60;
double retractheight = 150;
double retractforsecondmeasurement = 1;
bool domoveXY = true; //Enable XY movement false
bool dodualcycle = true; //Do probing from 2 cycles, first with Fast and second with Slow feedrates
if(!exec.GetLED(56)||!exec.GetLED(57)||!exec.GetLED(58)) // If machine was not homed then it is unsafe to move in machine coordinates, stop here...
{
MessageBox.Show("The machine was not yet homed, home the machine before probing!");
exec.Stop();
return;
}
while(exec.IsMoving()){}
double Xoriginalpos = exec.GetXmachpos(); // Get the current machine coordinates
double Yoriginalpos = exec.GetYmachpos(); // Get the current machine coordinates
if(domoveXY) // Make XY movement only if enabled
{
exec.Code("G00 G53 Z" + SafeZ); // Move Z up first
while(exec.IsMoving()){}
exec.Code("G00 G53 X" + probeX +" Y" + probeY); // Move to the probe sensor position in XY
while(exec.IsMoving()){}
}
if(dodualcycle)
{
exec.Code("G31 Z" + Zmin + "F" + FeedrateFast); // Do the Z probing with Fast feedrate first
while(exec.IsMoving()){}
exec.Code("G91 G0 Z" + retractforsecondmeasurement);
exec.Code("G90");
}
while(exec.IsMoving()){}
exec.Code("G31 Z" + Zmin + "F" + FeedrateSlow); // Do the Z probing again with Slow Feedrate to get a more accurate reading
while(exec.IsMoving()){}
if(!exec.Ismacrostopped()) // If tool change was not interrupted with a stop only then validate new tool number
{
exec.Code("G44 H1"); // Load tool offset one, note the tool lenght is defined in the tools menu
while(exec.IsMoving()){}
exec.Wait(200);
double Zup = exec.GetZmachpos() + retractheight;
if(Zup > SafeZ)
{
Zup = SafeZ;
}
exec.Code("G00 G53 Z" + Zup); // Move 10mm above probe plate
while(exec.IsMoving()){}
if(domoveXY) // Make XY movement back to start position only if XY movement is enabled
{
exec.Code("G00 G53 X" + Xoriginalpos +" Y" + Yoriginalpos); // Move back to the original XY position
while(exec.IsMoving()){}
}
}
think i might have do update Uccnc software because i dont have that option , ive been running the 1.2113 and think i read you have tested with 1.2117 . Anyways im gonna reinstall when i find that new version installer and have a new look at it .