Mr.Hotwire wrote:Fulling DZB280...
I cannot for the life of me find the parameters for the registers. I am NOT able to get the spindle to move, but using MODBUSmaster I am able to see the connection to the VFD is functioning.
[/color]
Hi,
Dont know if anyone monitors this thread nowadays, I have a Fuling dbz300 which is running via modbusez. the issue is that when 10000rpm is commanded in mdi the spindle only spins at 7500rpm. this is across the range of rpm. If I want 24000rpm I have to input 36000into UCCNC.
It seem like a multiplier or conversion factor within the Modbusez pluging. the VFD shows the correct rpm the spindle is turning at, IE 36000rpm UCCNC 24000 indicated at the vfd.
Any Ideas anyone?
other than tis issue modbusez works really well, Thanks for your effort Dan.
Phil