UCCNC Probing
4 posts
• Page 1 of 1
UCCNC Probing
by nyracerxxx » Sat Sep 28, 2024 6:21 pm
I have working fine, just wondering if there's a way to retract after probing to set distance. ie Probe Z, zero axis, retract .25" Like that?
- nyracerxxx
- Posts: 5
- Joined: Wed Feb 21, 2024 12:40 am
Re: UCCNC Probing
by cncdrive » Sun Sep 29, 2024 8:53 pm
If you probing from a macro then sure, you can code a
G91
G0 Z-10
G90
This will retract the Z with -10 relative to the probed Z coordinate.
G91
G0 Z-10
G90
This will retract the Z with -10 relative to the probed Z coordinate.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: UCCNC Probing
by nyracerxxx » Mon Sep 30, 2024 9:56 pm
Yes I figured that.
Is there a way to edit the macro's on the probe page?
Is there a way to edit the macro's on the probe page?
- nyracerxxx
- Posts: 5
- Joined: Wed Feb 21, 2024 12:40 am
Re: UCCNC Probing
by cncdrive » Tue Oct 01, 2024 6:51 pm
On the probing screen there is a Retract value and an Enable retract button.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
4 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 27 guests