Fusion 360 PP

[andrej]

What is the recommended postprocessor for Fusion 360 and UCCNC Turn?

[fred47]

Hi
I have a same question ....
I use UCCNC software 1.2116 turn version and Fusion 360.there are a postprocessor UCCNC on Fusion galerie but for 3 axis , not for lathe........
what post processor to use?

Is an update coming soon?

Fred

[Arne9999]

I'm using Fanuc in Fusion 360. I've just started, but so far so good (after changing the code to diameter instead of radius...). However, as I mentioned in another post, it moves at the same speed regardless of the operation. So if I set a feed rate of 150mm/min during a cut, it will travel at this speed throughout the entire process... very annoying.