I try to run the AXBB-E on a new Windows 10/64 with Mach3.
When starting Mach3, I get the "plugin defective" message.
The plugin was installed plugin with the UCx00 plugin installer.
The .net framework 4.8 in Windows is enabled.
What else can I try?
plugin defective message
3 posts
• Page 1 of 1
plugin defective message
by MrBean » Sat Sep 14, 2024 10:42 am
- MrBean
- Posts: 1
- Joined: Mon Oct 02, 2023 11:40 pm
Re: plugin defective message
by cncdrive » Sat Sep 14, 2024 3:39 pm
Enable the .net framework 3.5 in the Windows features and reboot Windows.
.net 4.8 is not backwards compatible with the .net framework 3.5.
.net 4.8 is not backwards compatible with the .net framework 3.5.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: plugin defective message
by cncdrive » Sat Sep 14, 2024 3:39 pm
Enable the .net framework 3.5 in the Windows features and reboot Windows.
.net framework 4.8 is not backwards compatible with the .net framework 3.5.
.net framework 4.8 is not backwards compatible with the .net framework 3.5.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests