VistaCNC P4-S pendant not working in 1.2116

[bob_mllr]

Hi,
I have a VistaCNC iMach III P4-S pendant that was working fine in V1.2113, but it is not operating correctly in 1.2116. I've sent a note to them as well, but was wondering if anything has changed in UCCNC that would effect their dll and mess with it working correctly?
Thanks,Bob

[cncdrive]

What is not working correctly?

[bob_mllr]

The pendant does not activate correctly - it does not show the axis selection or the coordinates. The jog wheel does not work, or initially jogs a little then stops working. Basically does not work correctly from startup. I can post a video?
Bob

[iiflyinverted]

I just updated to version 1.2117 from 1.2115. I have a Vistacnc P-4S and it is not working properly. I am certain the plugin is loaded with the latest version. I appear to be one of several people with this problen that may have started with ver 2.116. Thanks for any assistance

[iiflyinverted]

My Vistacnc P-4s pendant works on UCCNC ver 1.2117 using the default screenset but not the 2019 screenset. Any way to fix this?

[charliem]

You could always go back to the 1.2113. Just a thought.

[iiflyinverted]

Take a look at this post. It fixed my issue. The problem was occurring for me when using the 2019 screenset and not the default screenset.

viewtopic.php?f=3&t=5161