AXIS MOVEMENT

[MVPAWARDS]

I setup axis movement but nothing moves unless I go into the jogging screen and type in a number, when I close the UCCNC program and restart it the jogging is back to 0, any suggestions? This is my first time using UCCNC.

[MVPAWARDS]

OK Problem was fixed.
The gantry movement was fixed, however when a gcode file is loaded and ran, gantry movement is very slow

[Battwell]

g code gives a feed rate
eg f1000 for 1m/minute

if you dont have a feedrate in gcode the control will run at minimum speed.
you can also change the feedrate speed manually on screen by typing into the feedrate field and pressing enter.

[MVPAWARDS]

Where is the Feedrate field?