UCCNC Closing

[valhallaCNC]

Is there a reason UCCNC has to close when there is a Ethernet loss to the controller. I recently was experiencing intermittent Ethernet problems, very brief losses. With UCCNC closing it just seemed like the program was crashing. It was a hard problem to diagnose because every restart Ethernet was fine. A Estop with a Communication error message box would be a easy indicator of the problem.

[cncdrive]

UCCNC is built like that, if it looses the connection with the motion controller then it closes the application after asking to save datas.

[valhallaCNC]

Thanks for the reply,
If the machine has been homed with nothing else done . As soon as Ethernet link is lost, it closes without a prompt. Unless you're looking for a problem just gives the impression of a crash.