UC300ETH w/ 5LPT
3 posts
• Page 1 of 1
UC300ETH w/ 5LPT
by oksana » Tue Apr 16, 2024 10:11 am
I recently purchased a UC300ETH w/ 5LPT board and wondered if anyone has designed a case for 3D printing?
- oksana
- Posts: 1
- Joined: Tue Apr 16, 2024 10:08 am
Re: UC300ETH w/ 5LPT
by mickecarlsson » Wed Apr 17, 2024 6:44 am
Yes, someone has: https://www.thingiverse.com/thing:2853616
- mickecarlsson
- Posts: 52
- Joined: Mon May 11, 2020 2:42 pm
Re: UC300ETH w/ 5LPT
by formantjim » Wed Apr 17, 2024 6:29 pm
Thankyou Mike I was also looking for the same as well as the UCBB will be printing them off tonight.
This forum is the best!
This forum is the best!
- formantjim
- Posts: 76
- Joined: Fri May 31, 2019 5:28 pm
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: Bing [Bot] and 26 guests