For those not looking in subforums, I've posted some (mainly lathe) issues here:
https://www.forum.cncdrive.com/viewtopic.php?f=20&t=4708
Any ideas about the mentioned problems or recommended Fusion 360 lathe postprocessor?
New test release discussion
21 posts
• Page 3 of 3 • 1, 2, 3
Re: New test release discussion
by andrej » Fri Jan 19, 2024 1:55 pm
- andrej
- Posts: 24
- Joined: Tue Jun 07, 2022 1:56 pm
- Location: Piešťany, Slovakia
21 posts
• Page 3 of 3 • 1, 2, 3
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 29 guests