How do you put axis 5 and 6 into operation on axbbe??

[NIKIGIO]

How do you put axis 5 and 6 into operation on axbbe??
From 9 to 16 I have everything occupied (x,y,z,A,).
What is the right procedure?? I should connect an easydriver card.
Thanks for those who help me.

[cncdrive]

You can connect the 5. and 6. drive to any isolated outputs of the AXBB-E or to any non-isolated outputs on Port#3 of the AXBB-E.
For that you could use an LPT port compatible breakout board, e.g. a UCSB breakout board connected to port#3 of the AXBB-E.

[NIKIGIO]

therefore can I connect the PIN and STEP cables coming out of the easydriver board to PINs n°7 and n°8 of port 1 (isolated output)?
And in UCCNC configure the B axis with 7 and 8 ??
I have to use 5V stepper motors.
Thank you

[cncdrive]

Yes, you can do that.

[NIKIGIO]

If I understand correctly the ABXXE board drives the gnd side and not the v+ for the step and direction.
The easy driver only takes v+ signals.
Are we sure of this indication?? I don't want to cause any damage.
Thank you

[NIKIGIO]

Yes, you can do that.

I think it can't be done if you don't insert a microcontroller with 5v in between AXBB-e and easydriver.

[cncdrive]

You can use a resistor between the AXBB-E's isolated output and the positive supply voltage, then you can make the connection that way.

[NIKIGIO]

In summary I should put a resistor along the step wire and along the dir wire (is a 10k enough?).
Then connect cables to ports 7 and 8 of the axbb-e.
I would have understood this.
Sorry, it's not my subject.

Can you confirm it for me??