Hi everyone, the topic has almost certainly been discussed in the forum, but after some research I gave up!!!
I would like to know what is the correct procedure for working with the 4th axis on UCNC and FUSION 360.
Thank you all.
Helps for 4th axis
2 posts
• Page 1 of 1
Helps for 4th axis
by camivic » Sat Dec 09, 2023 5:28 pm
- camivic
- Posts: 26
- Joined: Thu Dec 08, 2016 10:32 pm
Re: Helps for 4th axis
by camivic » Sun Dec 10, 2023 7:53 pm
I managed to find some indications, but I have a small doubt: for the 4th axis I'm using a motor/controller with a 100CPR encoder.
Is it right to enter the value of 3.6 in the "Step per unit" setting and flag "Axis is Rotary"?
Is it right to enter the value of 3.6 in the "Step per unit" setting and flag "Axis is Rotary"?
- camivic
- Posts: 26
- Joined: Thu Dec 08, 2016 10:32 pm
2 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 27 guests