Wrong movement direction of the Z-axis during homing

[VAMAKA]

Hi, the problem is the Z-axis moving downwards during homing.

Details :
Software 1.2113
Firmware 1.0370
Device type UC300EHT- 5LPT

Z axis settings:
Step pin 7 port 2 Active low
Dir pin 8 port 2

Home pin 7 port 1 Active low

Homing speed up to 500 mm/min
Down 50

Softlimit - -160
Softlimit+ 0


Movements up and down are ok when controlled from the keyboard.
The machine has home switches on all axes and soft limits in use,
they work correctly.
I have tried with several settings without success.

Would there be a solution to the problem?

Best regards, VAMAKA

[ger21]

Toggle the "Dir. Positive" checkbox.

[VAMAKA]

Thank you very much for your help, it works now!