added gang drilling block.

[Battwell]

my next generation machine offering for the cabinet makers. development near finished now.
added a gang drilling block, modified all the controller macros again
this will be a very fast production machine !
shown running at 50m/minute here while on test.
uccnc obviously .



shows changover to multi tools
https://youtube.com/shorts/4G_BqjsQDXI? ... Izgpp7dqWH

shows changover to single point
https://www.youtube.com/watch?v=jkreCyShaqM

[UCCNCnoob]

Where can I buy this?

[Algone]

Good job!