g28 and write offset on homing
2 posts
• Page 1 of 1
g28 and write offset on homing
by asuratman » Wed Sep 20, 2023 7:33 am
If I use g28, when I cycle start, the endmill will drag on the top of fixture. To avoid this, I have to set Z axis Write Offset on Homing to 25 for example. Is there any other way to avoid dragging on surface fixture ?
- asuratman
- Posts: 118
- Joined: Sun Jan 28, 2018 1:50 pm
Re: g28 and write offset on homing
by asuratman » Thu Sep 21, 2023 2:17 am
Sorry, I found the answer from autodesk forum ...
- asuratman
- Posts: 118
- Joined: Sun Jan 28, 2018 1:50 pm
2 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: Google [Bot] and 8 guests