issues with both 2 versions of xbox controller plugin

[dhb9mm@gmail.com]

The original xbox plug in that comes with UCCNC if I don't turn on the xbox controller before i launch the program, or if the xbox controller turn off while the program is running, then the plugin cannot find the xbox controller. So to get it to work. I have to shut down UCCNC, turn on the xbox controller, then start UCCNC again.

I tried running the new version of the Xbox plugin vers. 2.060. I didn't like the way the buttons are configured, so I changed that. Once I got the buttons configured, I started getting and error message from UCCNC saying an exception had accrued, and the program will shut down. So I had to go back to the original one. IS there a way to set the updated version of the plugins back to default settings?

David

[eabrust]

Hi David,

The v2.060 xbox plugin is the one I wrote, the one that came w/ UCCNC is unrelated.

What are the 'default settings' you're trying to setup on the plugin with button assignments?


If you can tell me what you tried to configure or what settings you had by a screenshot that resulted in an exception error, it would help me to possibly fix it (or at least suppress an exception).

Last question, are you using an authentic xbox controller?

regards
Eric

[dhb9mm@gmail.com]

I figured out the issue with the updated version of the xbox controler. I had some settings messed up.

[eabrust]

Hi David,

If you can provide a little more info on what settings were messed up and caused an exception, I might be able to make improvements to the plugin to prevent that in the future.

Any info you can provide would be appreciated, glad you're up and running now.

regards
Eric