New AXBB-E help please

[originalsigns]

I'm hooking up my new AXBB-E and I have a few questions I hope someone can help me with. I know absolutely nothing about electronics, but I can follow simple directions. Right now I'm doing the wiring on my Microstep Drivers and things are going well with assigning the axis Pin #'s on the AXBB-E, but I don't understand the 5V aspect. To me it looks like the Microstep Drivers have the Direction(-) wired together and connected to the 5V0 INPUT (the one labeled POWER INPUT with the red LED right next to the 24V INPUT) is this correct??? I'm seeing 3 different things labeled 5V0 on the AXBB-E. It also looks like I need a separate 5V power supply connected to the same Power Input, I just want to make sure I'm doing this correctly so I don't release the magic blue smoke. I really appreciate any help, thank you!

[ger21]

To me it looks like the Microstep Drivers have the Direction(-) wired together and connected to the 5V0 INPUT (the one labeled POWER INPUT with the red LED right next to the 24V INPUT) is this correct???

No, use the "Power Out" 5V0 or 5V+ terminals. Section 9.2 in the manual explains this.
You need a single 5V power supply and a 24V power supply connected to the "Power Inputs" section. The "Power Out" terminals get there power from that 5V power supply.

[originalsigns]

Thank you for the reply, I'll give that a try. I guess the confusion is because the diagram ( 11 .Example drawing.) in the manual has the stepper motors going to the Power Inputs and the 5v Non Isolated outputs aren't on the diagram. I appreciate your help and clearing things up for me!

[ger21]

I guess the confusion is because the diagram ( 11 .Example drawing.) in the manual has the stepper motors going to the Power Inputs and the 5v Non Isolated outputs aren't on the diagram.

You're looking at the wrong diagrams I think.