I have a problem with the reset

[JHP03]

Everytime I start UCCnC the reset button keeps on blinking even in overide limits. the X Y Z limits led are lit in the Diagnostics page and the estop. Also the X Y Z A home led are lit to

[cncdrive]

If you can't remove the reset condition then your e-stop input is active. You can't override the e-stop button, only the limit switches with the limit override.
You can check the e-stop input state on the Diagnostics page.

The home LEDs are lit if you homed the machine.

[JHP03]

I unpressed the e stop button but i would still give me the reset problem. I tried override limits but still it wouldn't work.

[cncdrive]

Please post a printscreen of the UCCNC with your Diagnostics screen is selected when you can't remove the reset condition.