Hello,
Im using the UCCNC Software and vectric v carve pro for my laser. Is there any compatible postprocessor to get the right M10 M11 gcodes without changing anything?
Wich postprocessor would you use?
Thanks a lot!
Postprocessor for UCCNC using V carve pro 11.5 for laser
2 posts
• Page 1 of 1
Postprocessor for UCCNC using V carve pro 11.5 for laser
by Vikilaser » Mon Mar 13, 2023 10:15 am
- Vikilaser
- Posts: 42
- Joined: Mon Jan 23, 2023 11:03 am
Re: Postprocessor for UCCNC using V carve pro 11.5 for laser
by Vikilaser » Tue Mar 14, 2023 9:51 am
Now I found one for the UCCNC on the jtech Website. It was for inches and I changed hin to MM.
- Vikilaser
- Posts: 42
- Joined: Mon Jan 23, 2023 11:03 am
2 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 14 guests