Window Size

[ger21]

Personally, I'd much prefer to have the window remember where it was, rather than having it centered.
Centering is only better if you want it centered every time.

[cncdrive]

I can't answer the ETA question at the moment, because it is not even decided yet if and how this will go into a release as an onscreen option, but you can already place a window anywhere you want and can size it using the constructor macro.
Place this code into the M99998.txt constructor macro file, you can find that in the UCCNC/Profiles... folder.

Code: Select all

exec.mainform.Size = new Size(400, 300);
exec.mainform.Location = new Point(50, 50);

Ofcourse adjust the XY location coordinates and dimensions values in the code as you want.

Run the UCCNC and on the appearance page uncheck the Maximize screen on startup and Apply and Save settings and close the UCCNC.
Run the UCCNC again and the macro will resize the window and will move it to the location you defined.

[A_Camera]

Personally, I'd much prefer to have the window remember where it was, rather than having it centered.
Centering is only better if you want it centered every time.

Exactly. It's OK as a first start after a brand new installation to start centred, even maximized, but after that it should keep the size and position I set.

[marlboro]

Code: Select all

exec.mainform.Size = new Size(400, 300);
exec.mainform.Location = new Point(50, 50);

This worked great and was just what I was looking for in this case. Thank you.