Uc-300eth with triple beast using Lasertree LT-4LDS-V2

[Vikilaser]

* the laser also in the UCCNC Software is firing on pin1 port3 when I start the software and Im not able to control him by comands...

[Vikilaser]

When I Type in UCCNC M10 Q255 I dont see any Chance in the diagnostics. The ligth for the M3 comand works in the diagnostics...

[Vikilaser]

Do I need an relay to control the M3 M10 Qxxx comands?
Im really thankful for every help.

[Vikilaser]

Hi Formantjim,

Finaly it works. Im so happy with the laser. The issue was that I chosed the false pin (counted from the false direction site)
Thank you very very much for your help going step by step to search my Problem Now it reacts on M3 S... comands.
The UCCNC Software is great!!!

[Vikilaser]

Now also the M10/M11 comands are working i have had a false conection and config. Analog Port dont works, like cnc drive said. I misunderstanded and thoug I have to assign the laserpin to the analog Port. This was about my bad knowledge in electronics. I conected the pwm line to port3 pin1 and ground to pin 25 and it worked.
Thanks to all of you guys for understanding and helping me.
Great thanks to you Formantjim!
Also great thanks to Cnc-Drive!
Im very happy with my laser and UCCNC!