forum.cncdrive.com

by **Joepayne1** » Thu Jan 19, 2023 8:37 pm

Hello,

In the process of converting a Boxford 190VMC and am going to use the existing 24V supply to power the AXBB-E.
I measured the supply across the capacitor and it reads 27.4V. Is this likely to fry the board? If so, how do I go about reducing this voltage to make this compatible? Completely new to electronics so go easy!

by **cncdrive** » Fri Jan 20, 2023 7:40 pm

Up to 30Volts it should be fine.

by **cncdrive** » Fri Jan 20, 2023 7:41 pm

Up to 30Volts it should be fine "by design", but we did not test it with more than 24Volts.

by **fsli** » Sat Jan 21, 2023 2:18 am

Joepayne1 wrote:how do I go about reducing this voltage to make this compatible?

https://www.amazon.com/Stabilizer-Prote ... VHX8/?th=1

by **cncdrive** » Sat Jan 21, 2023 10:47 am

Or put a few diodes in series, they drop a fraction of volts, e.g. 0.6V drop per diode for a standard type diode.

by **Joepayne1** » Sun Jan 22, 2023 5:28 pm

Thanks for your replies. I will investigate both options as I would like to keep it to 24v.

forum.cncdrive.com

AXBB-E 24V Supply Too High?

AXBB-E 24V Supply Too High?

Re: AXBB-E 24V Supply Too High?

Re: AXBB-E 24V Supply Too High?

Re: AXBB-E 24V Supply Too High?

Re: AXBB-E 24V Supply Too High?

Re: AXBB-E 24V Supply Too High?

Who is online