Hi all,
is there any documentation on how and in what order to apply the M215 Px command in a G-code file? I have tried for hours, but I can't get a result. Can someone help me?
Peter
Pulleys and M215 Px
3 posts
• Page 1 of 1
Pulleys and M215 Px
by CADdy » Mon Aug 08, 2022 2:32 pm
- CADdy
- Posts: 148
- Joined: Sun Sep 17, 2017 2:26 pm
Re: Pulleys and M215 Px
by CADdy » Tue Sep 13, 2022 5:18 am
The only way to do anything with M215 is the following procedure directly after starting UCCNC:
M3
M215 P1
S4000
M5
After that I can load a nc program and then the pulley ratio is also correct. So a S5000 for example sets the motor to 8576 rpm. Of course this works only until UCCNC is terminated. At the next start you have to do this procedure again. It makes no sense to use M215 in a nc program. In this case there is no reaction from UCCNC at all.
It's a pity that no one was able to help me further. I think that a transmission between the motor and spindle is not a particularly unique case. The documentation does not show the required sequence. It is only briefly addressed M215 with parameter Px.
Peter
M3
M215 P1
S4000
M5
After that I can load a nc program and then the pulley ratio is also correct. So a S5000 for example sets the motor to 8576 rpm. Of course this works only until UCCNC is terminated. At the next start you have to do this procedure again. It makes no sense to use M215 in a nc program. In this case there is no reaction from UCCNC at all.
It's a pity that no one was able to help me further. I think that a transmission between the motor and spindle is not a particularly unique case. The documentation does not show the required sequence. It is only briefly addressed M215 with parameter Px.
Peter
- CADdy
- Posts: 148
- Joined: Sun Sep 17, 2017 2:26 pm
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 28 guests