network connection not possible

[gilles974]

hello

I received my AXBB-E today,
- 24v power supply connected
- network cable OK

the PC and the controller are connected to the switch

but no detection of the LAN the led remains off on the controller, no led is lit on the RJ45
PC is detected

network cable changed several times

thanks to +

[dezsoe]

You need a separate 5V power supply too. The 5V supplies the whole digital section, including the network.

[gilles974]

hello
I advance my leds on the RJ45 are lit
the "Ready" LED flashes
but the "link" led does not light up
the detection of the AXBB-E is not done
how to change IP 10.10.10.11 to 192.168.1.xx?

the card does not identify itself on the Network and Sharing Center.

++
gilles

[dezsoe]

The link will only light when the controller is talking to UCCNC or Mach.

The flashing Ready LED means that it is waiting for a DHCP server. No problem. In the UCCNC\Util directory there is a program called UCxxx_utility. Start it and setup the network as it is in the manual.

[gilles974]

Le lien ne s'allume que lorsque le contrôleur parle à UCCNC ou Mach.

- OK

UCxxx_utility. ne detecte aucun controleur

[gilles974]

hello

I FINALLY managed to detect the card in the UCxxx utility
my card as IP: 10.10.10.11 with DHCP connect to a network card (10.10.10.10)

I want my card to be on the 192.168.1.x network

do I have to manually change IP and GATEWAY and do a "save network setting"??

++
gilles

[Dazp1976]

hello

I FINALLY managed to detect the card in the UCxxx utility
my card as IP: 10.10.10.11 with DHCP connect to a network card (10.10.10.10)

I want my card to be on the 192.168.1.x network

do I have to manually change IP and GATEWAY and do a "save network setting"??

++
gilles

What network cable are you using?.
Crossover or standard patch?.
Use crossover cable for direct connection between axbb-e and pc network card.
Use standard patch to connect them via a switch.

Crossover won't work via switch, standard patch won't work direct.

[gilles974]

hello

saved, I managed to modify the IP of the box.

once the network card is installed with the IP 10.10.10.10
I put a patch cable and the LEDs flashed on the RJ45 connector and on the box, BUT still no detection by the UCxxx utility....
there I had the idea of disconnecting the 5V power supply waits a few seconds and reconnecting it, and there miracle the detection by the utility UCxxx.... has indeed taken place.
why this trick worked, I don't know

Thanks for your help
++
gilles