X axis exact center
4 posts
• Page 1 of 1
X axis exact center
by robiswood » Thu Aug 18, 2022 12:21 pm
Hi, I have been learning UCCNC for about a month. Is there a command I can put in the MDI field to tell the X axis to move to its exact center along the X axis on the spoilboard? Thanks.
- robiswood
- Posts: 1
- Joined: Thu Aug 18, 2022 12:17 pm
Re: X axis exact center
by charliem » Sat Aug 20, 2022 1:44 pm
If you know the max travel then in the mdi just put in the axis you want and the distance.
Regards
Charlie M
Charlie M
- charliem
- Posts: 108
- Joined: Sun Jan 01, 2017 5:37 pm
Re: X axis exact center
by formantjim » Sun Aug 21, 2022 10:38 am
As Charliem says if your spoil board is say 24" wide simply type GO X12.0 in MDI and it will move 12" to the centre.
- formantjim
- Posts: 76
- Joined: Fri May 31, 2019 5:28 pm
Re: X axis exact center
by charliem » Sun Aug 21, 2022 10:40 am
If you know the max travel then in the mdi just put in the axis you want and the distance.
Sorry I meant enter 1/2 the max travel
Regards
Charlie M
Charlie M
- charliem
- Posts: 108
- Joined: Sun Jan 01, 2017 5:37 pm
4 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 24 guests