If the limit switch is on, [there's many options to get this situation] I just move axis manually or remove a switch. [looks stupid]. How can I move an axis without a physical work?
Thank you.
The Limit switch is on, machine can't start.
3 posts
• Page 1 of 1
The Limit switch is on, machine can't start.
by mazinwoodcraft » Mon Feb 06, 2017 11:28 pm
- mazinwoodcraft
- Posts: 2
- Joined: Mon Feb 06, 2017 10:56 pm
Re: The Limit switch is on, machine can't start.
by zymurgy42 » Tue Feb 07, 2017 4:48 am
Will the Override Limts (on run page at bottom right, to the left of the RESET button), not allow this?
- zymurgy42
- Posts: 37
- Joined: Wed Jan 04, 2017 2:42 am
- Location: Melbourne, the most liveable city!
Re: The Limit switch is on, machine can't start.
by DerRoy » Fri Feb 17, 2017 9:23 am
Hi, yes it will.
Press override, unreset and you can move the axis away from the switch.
Press override, unreset and you can move the axis away from the switch.
- DerRoy
- Posts: 5
- Joined: Wed Jan 18, 2017 7:04 pm
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: Google [Bot] and 21 guests