forum.cncdrive.com

by **Robertspark** » Sat Jun 11, 2022 4:51 pm

there is an autoleveler plugin installed by default.

you will need to enable it and restart uccnc and then load it

by **charliem** » Sat Jun 11, 2022 6:41 pm

Hello Robert,
Thanks for the reply. I am aware of the auto leveler plugin. the last time I used it it only worked in MM units.
but I will have a look.

by **valhallaCNC** » Sun Jun 12, 2022 12:40 pm

G-code ripper generates this G-Code expression G0 Z [-0.026+#100] , for the Z - axis. UCCNC cannot resolve this without a separate variable being assigned first.

by **charliem** » Sun Jun 12, 2022 1:54 pm

Hi ,
can you give a example?

by **charliem** » Sun Jun 12, 2022 2:11 pm

Nevermind , I seen your post here http://www.forum.cncdrive.com/viewtopic.php?f=2&t=3876

Thanks. Maybe this will be a feature added at some point.

by **charliem** » Sun Jun 12, 2022 2:26 pm

Ok so with this in mind what good is the digitized file?

forum.cncdrive.com

Digitize file

Re: Digitize file

Re: Digitize file

Re: Digitize file

Re: Digitize file

Re: Digitize file

Re: Digitize file

Who is online