Hello,
Is it possible to add the screw mapping function to UCCNC as it is in Mach3?
Thanks & Greetings
Rene
Screw Mapping
3 posts
• Page 1 of 1
Screw Mapping
by Toecutter » Thu Jun 09, 2022 6:30 am
- Toecutter
- Posts: 6
- Joined: Tue Jan 02, 2018 4:33 pm
Re: Screw Mapping
by cncdrive » Thu Jun 09, 2022 11:36 am
Yes, it is possible. But the UCCNC does not have this function.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Screw Mapping
by cncdrive » Thu Jun 09, 2022 11:37 am
Yes, it is possible. But the UCCNC does not have this function. I'm not sure if and when we will add it.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest