The Probe sensor was active.

[kim@moltved.dk]

Thangs

[kim@moltved.dk]

After update output port 5 pin 14 on my UC300ETH is not working, when downgrade it work.

[kim@moltved.dk]

Just test with a total new installation with out changing anything, except for add the licens file.
Port 5, pin 14 i still activ and can be changed.

[cncdrive]

Because what was fixed in this release was only the pendant based problems/probe sensor issue, nothing else.

Did you report your issue about port 5. pin 14. in the forum in a new topic or ...? If not then please do so.

[kim@moltved.dk]

Yes but the port 5 pin 14 is not a problem in the orginal 1.2115! So somthing is changed that made this problem!

[cncdrive]

I don't think that we changed anything about it.
Maybe you configured more than one function to that pin.

Dezsoe, could you please verify this for me. Thanks.

[kim@moltved.dk]

There is only 2 macros that use it that is start and stop 99998 99999. And both set it to low.
It even go in on state on a clean instalation. With default setup and macros. No setup!

[dezsoe]

The bug exists. When the firmware update is ready pin 14 goes on. When I configured the M3 relay onto this pin then it worked, but when I zeroed out the M3 relay then it went wrong again.

[cncdrive]

Thanks Dezsoe, the API contains the new SPI bus communication function also for the UC300ETH which pins are on port#5, so the issue is probably caused by that.
We will check and correct it.

[kim@moltved.dk]

Hi any update?